Loading... Please wait...

Categories

Decal Installation

Decal Installation

PAGE UPDATE IN PROGRESS

Step 1
When you receive your decal, apply pressure evenly on the tranfer tape side with squeegee or plastic card. This will ensure the vinyl decal stays on the transfer tape and does not separate along with the backing paper during installation. Clean application surface throughly (DO NOT use ammonia based cleaner such as Windex). Place decal on desired location and apply masking tape across the top, creating a hinge.

Step 2
Flip decal up and pull backing paper off, exposing addhessive.

Step 3
Bring decal down while still holding the bottom end up; apply firm pressure with your thumb (or with squeegee) and rub graphic area from center out to edges forcing all the air out.

Step 4
Let decal sit for a few minutes, then gently remove transfer tape by pulling it straight back, leaving the graphic on the surface. If you notice any air bubbles, use a pin and poke a tiny hole. Then squeeze the air bubble out by using your thumb or squeegee. Let decal sit for 24 hours before washing your car. You can still drive your car and the decal will not lift off.

Congratulations!
Your are now ready to show off your new decal!

newsletter

Follow us on

Copyright 2017 Outlaw Custom Designs, LLC. All Rights Reserved.
Sitemap | Bigcommerce Premium Themes by PSDCenter